SP-12000 Single Output Power Supply With PFC

SP-12000 High power switching power supply.Supports 90-270VAC full range input, wide voltage input, no need to switch.Moreover, the voltage and current output can be adjusted at will and can also be locked.Other output voltages also support customization.
This product has a large smart display screen.There are voltage display, current display, electricity consumption display and power display.Each chassis can be air-cooled through an internal speed-controlled fan, and the operating temperature is close to 60°C.If you have any questions, please do not hesitate to contact us atEmail: [email protected]

Запросить цитату

Описание

Функции

1、Voltage input range: 95-265VAC
2、Protection type: short circuit/overcurrent/overvoltage/overtemperature
3、Power factor PF≧0.99
4、Working efficiency up to 93%
5、485 communication control

Technical Parameters

Модель		SP-12000-24	SP-12000-36	SP-12000-48	SP-12000-60	SP-12000-110	SP-12000-220
Выход	DC voltage	24В	36В	48В	60V	110 В	220В
	Рейтинг тока	500A	333.3A	250A	200A	109A	54.5A
	Текущий диапазон	0 – 500A	0 – 333.3A	0 – 250A	0 – 200A	0 – 109A	0 – 54.5A
	Номинальная мощность	12000W
	Пульсация	500мВ	500мВ	600мВ	600мВ	1000 мВ	1500mV
	Constant current optimum range	12 – 24V	18 – 36V	24 – 48V	30 – 60V	55 – 110V	110 – 220V
	Rated voltage accuracy	± 1,0%
	Регулирование линии	± 1,0%
	Регулирование нагрузки	± 1,0%
	Startup & Rise Time	1500mS，700mS/230VAC(Fully loaded）
Вход	Диапазон напряжения	95-190VAC(Output Current 50%),195-265VAC(Output Current 100%)
	Диапазон частот	45Hz – 65Hz
	Коэффициент мощности	PF≧0.99/230VAC(Fully loaded)
	Efficiency(MAX)	90 %	91.5 %	92 %	92 %	92.5 %	93 %
	переменный ток	＜110A
	Ток утечки	＜3.0mA / 240VAC
Protect	Короткое замыкание	When the constant current is entered and the voltage is lower than 10% of the rated voltage, the output is shut down and locked after 1 second, and recovers after restarting.
	Overcurrent	The user can set the over-current value to delay the output for 5 seconds and then shut down the output, and then resume after restarting.
	Overpressure	Users can set the overvoltage value to shut down the output voltage, and restore after restart
	Перегрев	Shut down the output, automatically recover or restart after the temperature drops
Функция	Output voltage adjustment	0 – 26.4V	0 – 39.6V	0 – 52.8V	0 – 66V	0 – 121V	0 – 242V
	Output constant current adjustment	0 – 625A	0 – 416A	0 – 312A	0 – 250A	0 – 136A	0 – 68A
	485 Communications	MODBUS Communication Protocol
	Isolated auxiliary power supply	12V 0.5A (Need customization)
	Output remote switch	Default power on, high level power off （5V-12V） (Need customization)
	Alarm signal output	Power Good Signal (Dry Contact≦36V,0.1A)(Need customization)
Среда	Рабочая температура	-20 – +60℃
	Рабочая влажность	-20 – 90% RH No condensation
	Температура и влажность хранения	-40 – +85℃, 10 – 95% RH No condensation
	Устойчивость к вибрации	10 – 500Hz, 2G 10 Min/Cycle, X、Y、Z 60 Min
Безопасность	Устойчивость к изоляции	Input to Output :100Mhms/500VDC/25℃/70%RH
Безопасность	Сопротивление давлению	I/P-O/P :2KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
other	Размер	455345251mm（LWH）
other	Net Weight	22 KG
Примечание	1. All parameters are measured at 230VAC input voltage, rated load and 25℃ unless otherwise specified. 2. Ripple and noise voltage are measured with a 20MHz bandwidth oscilloscope with 0.1μ and 47μ capacitors added to the end of a 12-inch twisted pair, and measured at 20MHZ bandwidth. 3. Accuracy: includes setting error, linear regulation rate and load regulation rate. 4. Output must be derated for low input voltage conditions, please refer to the static characteristic curve for details. 5. Startup time is measured under cold start, and frequent switching may increase the startup time.